LT-WJ05 Edge tester | edge tester | edge tester | sharp edge tester
|
Technical parameters |
| 1. Material: Stainless steel S.S.T |
| 2. Volume: 290*190*100mm |
| 3.Weight: 3.61kg |
| 4. Accessories: Teflon paper PTFE Tape |
|
Scope of application |
| 1. Stick the PTFE adhesive paper on the mandrel as required, and then rotate the mandrel 360° along the reachable edge to be tested, and check whether the test adhesive paper is determined by gravity to determine whether the ball can fully pass the test template and cut the length. Calculate the percentage of tape length to be cut. If 50% of the adhesive paper is cut, the edge is considered a sharp edge. |
| 2. The edge to be tested shall be the reachable edge determined after the accessibility test of the toy part or component. |
| 3. If the touchable edge of the toy as a whole cannot be tested, in the case of simulating the whole toy, the touchable edge can be removed for separate testing. |
| 4. The key to the sharp edge test is how to fix the edge to be detected, and ensure that the mandrel is at a right Angle to the edge, and there is no relative movement between the mandrel and the edge in the test. |
| 5. In the process of rotating the mandrel, it should be ensured that the pressure applied to the mandrel is continuous stability. |
| 6. Age limit: less than 36 months, 37 months to 96 months |
| 7.Edge test requirements: sharp edges are not allowed on toys; A functional sharp edge may be present on the toy, but a warning must be provided. |
|
Application method |
| ● USA: 16 CFR 1500.48, ASTM F963 4.8;● EU: EN-71 1998 8.2;
● China: GB/6675-2003 A.5.9. |
Write your message here and send it to us
